Posted on Leave a comment

Care – Danish Oil

Danish Oil Care

For Watco Danish Oil. Please read instructions on the back of the product if you are using a different Danish Oil.

APPLICATION

Use only when air (ambient) temperature is between 60- 90°F (16-32°C) and relative humidity is below 85%. Allow for longer dry times during damp and humid conditions. Mix or shake material thoroughly to ensure that any settled pigment is re-dispersed before application. Stir occasionally during use. Apply a test sample on a small inconspicuous area before proceeding with the entire job. Apply one coat of Watco Danish Oil liberally with a brush or clean lint free rag. Allow to penetrate for 15 minutes then remove excess by wiping with a rag in the direction of the grain. If additional coats are needed, reapply allowing an additional 15 minutes penetration. Wipe surface completely dry. Removal of all excess material is essential to ensure proper dry time and proper adhesion of topcoat.

MAINTENANCE

Apply fresh coats as needed to repair surface scratches and to remove minor stains. Burnish affected area with fine steel wool or #220-grit sandpaper, then apply the Watco Danish Oil color originally used to finish the wood. CLEAN UP Application tools or brushes should be cleaned with mineral spirits or paint thinner.

Source: https://www.rustoleum.com/product-catalog/consumer-brands/watco/danish-oil

Danish Oil Care

Leave a Reply

Your email address will not be published.